Search

Dana 60 and 70 Pinion Flange

Products > SMALL PARTS > Dana 60 and 70 Pinion Flange

Dana 60 and 70 Pinion Flange

    • 1
Dana 60 and 70 Pinion Flange.
Contact purchase
shared：

  • COMPANION FLANGE

  • Fits Dana 60, 61, 70 FRONT or REAR ends

  • 29 splines

  • 1.875 inches seal surface

  • 1.5 inches length through splined hole

  • 8 mounting holes

    • M12-1.75T Metric thread

    • Note: Only 4 holes are needed for mounting flange yoke

    • See bottom of this page for flange yoke choices

    • 4.25 inch bolt circle - diagonally

  • 1.955 inches from flange mounting face to end of splined hole

  • 2 inch male pilot diameter

  • Can be used with 1310, 1330, 1350 and 1410 flange yokes

  • Great way to connect any 1310, 1330, 1350 or 1410 series driveshaft to a Dana 60, 61, 70 Front or Rear end



Name
Phone
Email
Corporate name
Address
Leaving Message*
 
Verification code
Submit

32 Spline Multi-Pattern Flange

32 spline output flange with 2" centering pilot and both 2.5" x 2.5" and 3" x 3" bolt threaded bolt patterns. Uses 7/16" NF threaded holes and includes 4 bolts and lock washers. It uses a 2.125" seal surface, if your current output seal is smaller than that you will need to replace your output seal.
Previous： Double Cardan CV Ball Seat Repair Kit
Next： 32 Spline Multi-Pattern Flange
TOP